Always use as little attenuation as possible to get the best possible signal-to-noise ratio.

OUTPUT. This is the balanced microphone level output of the ULTRA-DI.

Connection to the microphone input should be made with a standard high quality balanced cable.

Never connect pin 2 or 3 to pin 1 and never disconnect the shield from pin 1, or the unit will not work on phantom power.

Depending on the grounding of the connected devices linking or disconnecting will reduce hum or prevent ground loops.

GROUND LIFT ON means no interconnection.

BATTERY COMPARTMENT.

Loosen the screw to open the compartment and to replace the 9 V battery.

When the ULTRA-DI is switched on battery power the LED blinks, when it stops blinking it is time to change the battery.

DI100 Configurations The next section will show several different ways the ULTRA-DI can be hooked up.

Tapping signal from the (Bass) guitar Microphone Input Out DI100 In Link Out Fig 2.1: Guitar DI Guitar AmpMixerv Prev Next.

Behringer Ultra Di100 Schematic Manual Manualsbrain Copyright